Reconnecting Your Alarm.com Doorbell

This is done in 3 steps. Resetting the doorbell back to factory defaults, connecting the doorbell to your home network & adding the doorbell to your existing alarm.com account.

Resetting the Alarm.com doorbell to factory default

Reset procedure	Reset button location	Reset button image
Press and hold the doorbell button for at least 45 seconds until the LED starts blinking red and green. Wait for the device to reboot. Once it starts blinking white you may move to the next step.	The doorbell button on the front of the unit.

Connect the Alarm.com doorbell to the network

AP Mode (recommended)

1. The camera is in Access Point (AP) mode when the button LED is blinking white. If necessary, access AP mode by holding down the doorbell button for 35-40s and release when the LED turns to blinking white.
2. Using a Wi-Fi-capable device (e.g., smartphone or computer), find and connect to the camera’s network; the SSID should have the format ADC-VDB770 (XX:YY:ZZ) where XX:YY:ZZ is the last 6 characters of the MAC address.
3. On the same device, open a web browser and enter http://vdb770install or 192.168.1.1 in the web address field. Follow the on-screen instructions to add the ADC-VDB770 to the Wi-Fi network. Verify the LED turns solid green, indicating the connection is complete.

WPS Mode (alternate)

Note: Use WPS mode if you have easy access to the Wi-Fi router and the router has the WPS feature enabled. Note that some Internet Service Providers disable the WPS feature on customer routers. AP mode is the most reliable method for installing this device.

1. After the boot process is complete (the camera’s LED will be blinking white), hold down the doorbell button for 30-35s and release when the LED begins to blink blue.
2. Activate WPS Mode on the router. The router will begin to connect to the Wi-Fi network. Verify the LED turns to solid green, indicating the connection is complete.

Enroll the Video Doorbell to the account

Note: There are two ways to add the doorbell to your account. Please choose one of the following ways.

Enroll the ADC-VDB770 using the Customer app:

1. Log into the Customer app.
2. Tap .
3. Tap + Add Device.
4. Tap Doorbell Camera.
5. It should then show your ADC-VDB770 doorbell. Tap Install
6. Follow the on-screen instructions to complete the enrollment process.

Enroll the ADC-VDB770 using the Customer Website:

1. Log into the Customer Website.
2. Click Settings.
3. Click Manage Devices.
4. Click Add Device.
5. Click Doorbell Camera.
6. Click Install on the device to be installed
7. Follow the on-screen instructions to complete the enrollment process.